EDI Model AT Linear Anode
Materials Quantity and Price Estimator
for Aboveground Storage Tank Bottoms

Enter design parameters in the yellow area - click Estimate Button
Then Read details, material requirements, and cost estimates below.

Units of Measure English   Metric
Tank Diameter ft. Anode Spacing ft.
Ring Wall to Junction Box ft. Outer Loop to Ring Wall ft.
Current Density mA/sq.ft.    OR  Total Current Requirement Amps
  
Calculated Quantities
  Details
Tank Bottom Area Total Current Requirement
Number of Loops Total Protected Area
Largest Loop Diameter Anode Length
  Required Materials
50 ft. Anodes Pin-end & Socket-end lead wires
Tee-end lead wires
 Pin-end & Socket-end wire length
Tee-end wire length Recommended Ref Electrodes
(EDI Model US-CUG)
  Estimated Costs: (Suggested Retail Prices)
Pt on Cu cored Ti MMO on Cu cored Ti  
Connector Lead Wires Estimated Man-hours for Installation
Reference Electrodes    
NOTES:
1.Required materials based on a single circuit with a power feed on each end and intermediate tee feeds as required. Tee-end feeds are recommended every 1,000 ft. (300 m). One reference electrode is recommended for every 50 feet (15 m) of tank diameter.
2. Pt and MMO perform the same in this application. Choice is based on personal preference.
3. Estimates based on 1/3 man-hr. per anode. Experienced crews should take less time.

Estimator Created by DelWeg Logo
All calculations are based on this schematic.
 Model AT Linear Anode Data Sheet

Model US Reduced Diameter Reference Electrode Data Sheet

Description (or Basis) of Calculations